Skip to main content
Skip table of contents

Applications: Additional Application Settings

Configuring Application Log Level

Application Logging Settings

  1. Log in to your Software Appliance.

  2. Open the Application page.

  3. In the section Additional Application Settings the Application Log Level is set to INFO as default.

    Drop down list Application Log Levels:

    • INFO (default)

    • DEBUG

    • TRACE

    • ALL

  4. Specify the log level and confirm with Save Settings.

If you change the log level beyond INFO, a warning message is displayed that changing the log level may log secrets and trigger a restart of the Software Application.

Confirm the change with Update Log Level.

A permanent warning is displayed on all pages if the configured log level is higher than INFO, as sensitive data could be leaked.

Excessive Data Logging Enabled

It is not recommended to run SignServer with an elevated log level. Secrets and/or confidential data could show up in your log files.

The warning includes a built-in Configure Application Logging button that directs you to the Application Logging Settings.

Application Server Settings

The following describes how to in- or decrease the Application Server Settings.

The permitted number of bytes can be increased if larger files need to be uploaded for signing.

  1. Log in to your Software Appliance.

  2. Open the Application page.

  3. In the section Application Server Settings the maximum permitted number of bytes per request can be defined.

    Default value: 33554432
    Max value: 2147483648 (2 GB)
    Min value: 1048576

  4. Confirm the entries with Save Settings.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.