Breadcrumbs

Step 3: Installing Hardware Appliance with Existing Management CA

Install the Hardware Appliance with an existing Management CA:

  1. Install the Hardware Appliance as described in the sections of the Initial Set-up until you reach the WebConf installation wizard step Management CA Settings.

  2. Activate the option Use existing Management CA.

  3. In the field SuperAdmin full Subject DN, paste the value for clientcert that you have copied in the last step of Step 2: Installing the First Hardware Appliance:


    Start Management CA Settings.png

    WebConf > Management CA Setting: Paste clientcert



  4. You can now complete the installation.


Both Hardware Appliances are now using the same certificate as super admin: the certificate that is installed in the smart card. Only the first Hardware Appliance hosts the ManagementCA.

The following illustration shows the EJBCA Administration page of the Hardware Appliance hosting the ManagementCA.

EJBCA Administration page.png

First Hardware Appliance: EJBCA Administration page


The EJBCA Administration page of the Hardware Appliance without ManagementCA looks as follows:

EJBCA Admin page without MgmtCA.png

Second Hardware Appliance: EJBCA Administration page