Skip to main content
Skip table of contents

Create a User Account with OAuth

The following describes how to add an OAuth user account for the Software Appliance. Adding a new user account also allows you to remove the Initial OTP User to avoid security concerns.

Proceed as follows to create a new User Account for the Software Appliance:

  1. Log in to your Software Appliance and open the Access page.
  2. In the section User Accounts, click Add User Account.

  3. The corresponding form will open. Enter the required information.
  4. For Authentication Type, select the option Internal OAuth Provider
  5. In Credentials, specify the Username

    Username

    The rules are as follows:

    • 3 characters minimum with at least 1 alpha-numeric character

    • 64 characters maximum



  6. Specify the Password for the new user account and repeat it for confirmation.

    Password

    The rules are as follows:

    • 8 characters minimum

    • 64 characters maximum

  7. Click Add User Account to confirm your entries. The new User appears in the list of User Accounts.

    Notice!

    Since the virtualization platform is often managed by a different person than the Software Appliance, you should remove the Initial OTP User once you have created a new user account in order to avoid security issues. As you are currently logged in with the Initial OTP User account, you must log in again with the newly added user account before removing the initial account.

  8. Log out and then log back in with the newly created user account.
  9. Next, remove the Initial OTP User to avoid security issues, see Setup Steps Overview: Step 2 - Remove the OTP User.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.