Skip to main content
Skip table of contents

First Login to the User Interface (Webconf)

Attention, if you want to add this Next Generation Hardware Appliance as a Node to a cluster, you must not login to Webconf. Please refer to Connect to a Cluster.

After setting up the IP address and obtaining the OTP those values are used to login to Webconf.

  1. Make a note of the IPv4 address and the OTP on the front display.

  2. Open an internet browser and browse the IPv4 address as an URL.

    CODE
    https://xxx.xxx.xxx.xxx
  3. The browser will navigate to the login page of Webconf.

  4. Enter the OTP to login and gain access to the Overview page of Webconf.

Next, the steps described in Fresh installation need to be followed.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.